DIY Serving Tray – By Morena of Morena's Corner

Today I’m excited to show you how to use your favorite fabric to make a fabulous serving tray. Trust me, everyone will be asking where you got your one of a kind tray!


  • Wood Tray
  • Paint
  • Fabric
  • Mod Podge
  • Pour On Resin

Step one: If your tray is unfinished like mine, paint it.

Step two: Measure and cut your fabric to fit inside the tray.

Step three: Apply a layer of Mod Podge to the tray. Smooth the fabric on top and cover it with another layer of Mod Podge.

Step four: After it has dried, seal the fabric again with Mod Podge. It’s critical to seal the fabric because the resin will stain unfinished fabric and leave unsightly splotches on the fabric. I usually seal my fabric three times to make sure I didn’t miss anything.

Step five: Once the fabric is dry, mix the resin according to the manufacturer’s instructions. The product I use requires me to mix equal parts of each of the two solutions. Pour the resin over the fabric.

You will likely have air bubbles in the resin. You can easily remove these with a heat tool. I like to use my heat embossing tool to quickly pop the bubbles. Be careful not to overheat the resin.

Once it dries, the resin has a beautiful glass-like finish. It is waterproof and permanent. This would make a lovely gift, especially if you paired it with matching napkins or place mats. A coordinating table runner would look awesome, too. What fabric will you use in your DIY tray?

This entry was posted in Uncategorized and tagged , , , , , . Bookmark the permalink.

Comments are closed.